ISO 4359:2022

مواصفة قياسية دولية   الإصدار الحالي · اعتمدت بتاريخ ١٩ ديسمبر ٢٠٢٢

Flow measurement structures — Rectangular, trapezoidal and U-shaped flumes

ملفات الوثيقة ISO 4359:2022

الإنجليزية 79 صفحات
الإصدار الحالي
247.51 USD

مجال الوثيقة ISO 4359:2022

This document specifies methods for the measurement of flow in rivers and artificial channels under steady or slowly varying flow conditions, using certain types of critical-depth flumes (also known as “standing-wave flumes”). A wide variety of flumes has been developed, but only those critical-depth flumes which have received general acceptance after adequate research and field testing, and which therefore do not require in situ calibration, are considered herein.

The flow conditions considered are uniquely dependent on the upstream head, i.e. subcritical flow must exist upstream of the flume, after which the flow accelerates through the contraction and passes through its critical depth (see Figure 1). The water level downstream of the structure is low enough to have no influence upon its performance.

This document is applicable to three commonly used types of flumes, covering a wide range of applications, namely rectangular-throated, trapezoidal-throated and U-throated. The hydraulic theory behind this document was presented in Reference [7].

This document is not applicable to a form of flume referred to in the literature (sometimes called a “Venturi” flume) in which the flow remains subcritical throughout.

NOTE      The Venturi form of flume is based on the same principle as a Venturi meter used within a closed conduit system and relies upon gauging the head at two locations and the application of Bernoulli’s energy formula.

الأكثر مبيعاً

GSO 150-2:2013
 
مواصفة قياسية خليجية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
YSMO GSO 150-2:2020
GSO 150-2:2013 
لائحة فنية يمنية
فترات صلاحية المنتجات الغذائية - الجزء الثاني : فترات الصلاحية الاختيارية
YSMO GSO 2055-1:2020
GSO 2055-1:2015 
مواصفة قياسية يمنية
الأغذية الحلال – الجزء الأول : الاشتراطات العامة للأغذية الحلال
GSO 2055-1:2015
 
لائحة فنية خليجية
الأغذية الحلال – الجزء الأول : الاشتراطات العامة للأغذية الحلال

اعتمدت مؤخراً

ISO 6182-18:2025
 
مواصفة قياسية دولية
Fire protection — Automatic sprinkler system — Part 18: Requirements and test methods for flexible sprinkler hose
ISO 8426-1:2025
 
مواصفة قياسية دولية
Hydraulic fluid power — Determination of derived displacement of positive displacement pumps and motors — Part 1: Two-step Toet method
ISO 21121:2025
 
مواصفة قياسية دولية
Spices and condiments — Dried lime (whole, slices and ground) — Specification
ISO 15614-2:2025
 
مواصفة قياسية دولية
Specification and qualification of welding procedures for metallic materials — Welding procedure test — Part 2: Arc welding of aluminium and its alloys